Tone and Technique

How do brass players change pitch?

Brass players change pitch by combining lip tension, air speed and tongue position, plus valves or a slide to change tube length. Here's how each part works.

On this page
  1. Start with the buzz
  2. The harmonic series
  3. Lips and aperture
  4. Air speed and tongue position
  5. Valves change tube length
  6. Slides change tube length
  7. Putting it together
  8. Practice tips

Brass players change pitch in two main ways. They change the lip buzz and the air speed, which selects a different partial of the instrument’s harmonic series. They also change the length of the tubing: valves on a trumpet, or a slide on a trombone. Most notes use both.

Start with the buzz

Every brass note starts with a buzz. Air passing through the lips makes them vibrate against the mouthpiece, and the pitch of that buzz pulls the instrument toward a note. The instrument then sounds the pitch that best matches the buzz.

The harmonic series

A brass instrument with a fixed length of tubing can only sound a set of pitches, called the harmonic series or partials. The notes are spaced further apart at the bottom of the series and closer together higher up. Players use their lips and air speed to choose which partial sounds. This is why the higher you go in the series, the closer together the notes sit.

Lips and aperture

The lips change the size and tension of the opening, called the aperture. Higher partials usually need a firmer, smaller opening, and lower partials need a looser, larger one. Many teachers describe this as a tighter drumhead for higher notes. Keep the center of the lips relaxed and the corners firm, so the lips can still vibrate freely.

Air speed and tongue position

Faster air helps the lips vibrate at higher partials. Raising the middle and back of the tongue toward an “ee” vowel narrows the space in the mouth and speeds up the air. Lowering the tongue toward an “ah” vowel opens the space and slows the air for lower notes.

Valves change tube length

A trumpet has three valves. Pressing a valve adds a loop of extra tubing, which lowers the pitch by a fixed amount:

Valve Lowers the pitch by
1 2 semitones (a whole step)
2 1 semitone (a half step)
3 3 semitones (a minor third, or one and a half steps)

Combinations add together. Valves 1 and 2 together lower the pitch by 3 semitones, valves 2 and 3 by 4, valves 1 and 3 by 5, and all three by 6. The chromatic scale chart shows the combination for each note. Players combine these valve changes with lips and air to select notes.

Slides change tube length

A trombone uses a slide instead of valves. Moving the slide in or out changes the tubing length continuously, so the trombone can sound any pitch within its range, not only fixed steps. Players still use lip and air changes to select partials.

Putting it together

When a trumpeter plays a note, the valves set the tube length, and the lips and air select the partial. A trombonist sets the slide position and uses the lips and air in the same way. Together, these choices produce the note.

Practice tips

  • Buzz on the mouthpiece to find pitches before you add the instrument. See buzzing on the mouthpiece.
  • Practice lip slurs on a single valve combination to train the lips and air.
  • Check your pitch with a tuner, especially when you combine valves.

For the tongue and air in more detail, read what is tonguing in trumpet. For the upper register, see how to get better at playing high notes on trumpet.

The complete guide to tone and technique

How to Improve Your Trumpet Tone (and Fix a Shrill Sound)
Read the guide

Keep exploring

Guides from other topics

All topics →