Tuba and Euphonium

4-Valve Euphonium and Baritone Finger Chart (Bass Clef Scales)

Valve fingerings for the 4-valve euphonium and 3-valve baritone in bass clef, from C3 to C4, with the valve arithmetic and fourth-valve alternatives.

On this page
  1. How to read the chart
  2. The valve arithmetic
  3. C major scale on a 4-valve euphonium
  4. The 3-valve baritone
  5. Fourth-valve alternatives
  6. Octave check against the tuba
  7. Tuning and practice
  8. Where to go next

How to read the chart

The chart below gives sounding (concert) pitch in bass clef. Valve numbers are for a 4-valve euphonium in B♭, with 0 meaning open. Where two combinations are listed, both give the same note, and either can be used.

A euphonium is in the same key family as the BBb tuba, so the valve arithmetic is the same. The notes are not the same, though, because a euphonium’s tubing is about half as long, so its harmonic series sits an octave higher. The tuba fingering chart uses the same valves, but its note names are different.

The valve arithmetic

Valve Lowers the pitch by
1 2 semitones (a whole step)
2 1 semitone (a half step)
3 3 semitones (a minor third)
4 5 semitones (a perfect fourth)

Combinations add the lowering together. So 1-3 and 4 both lower the pitch by 5 semitones, and 2-4 and 1-2-3 both lower it by 6.

C major scale on a 4-valve euphonium

Note 4-valve 3-valve
C3 1-3-4 Not available
D3 3-4 (or 1-2-4) Not available
E3 1-2-3 (or 2-4) 1-2-3
F3 1-3 (or 4) 1-3
G3 1-2 1-2
A3 2 2
B3 1-2-3 (or 2-4) 1-2-3
C4 1-3 (or 4) 1-3

The lowest notes of the scale, C3 and D3, need the fourth valve. A three-valve instrument cannot reach them with any valve combination on the partials used here, and most players do not try.

The 3-valve baritone

A three-valve baritone or euphonium can play the scale from E3 to C4, using the combinations in the 3-valve column. On the partials used for this scale, C3 and D3 need the fourth valve. That is why the 3-valve column leaves them out.

Fourth-valve alternatives

The fourth valve gives alternatives for notes that are normally played with other valves.

  • 4 instead of 1-3. Both lower the pitch by the same amount. Some players prefer the fourth valve for F3 and C4, because it often sits better in tune.
  • 2-4 instead of 1-2-3. Both lower the pitch by 6 semitones. This is the usual alternative for E3 and B3.

Whether the fourth valve improves intonation depends on the instrument. Some euphoniums are compensating, which adds extra tubing when the fourth valve is pressed. For how that works, see the fourth valve on a euphonium.

Octave check against the tuba

The valve combinations on a euphonium are not the same as those on a BBb tuba for the same note name. For example, a tuba plays C3 with 1-3 on its third partial, while a euphonium plays C3 with 1-3-4 on its second partial. The same valve combination on the same partial sounds an octave higher on a euphonium than on a tuba. Check the octave of every note in your part before you play it.

Tuning and practice

  • Check every note with a tuner. Fourth-valve combinations are easy to play flat or sharp if the lip is not matched to the pitch.
  • Practice scales slowly. Start with the notes you can play cleanly, and add the lowest notes once the embouchure is steady.
  • Use the chart as a reference, not a rule. Charts vary between makers, and the best fingering can depend on the instrument.

Where to go next

For the notes of a BBb tuba, see the tuba fingering chart and the tuba C major scale. To understand how the baritone and euphonium differ, read euphonium vs baritone vs tuba.

The complete guide to tuba and euphonium

About the Tuba: Sound, Sizes and What It's Like to Play
Read the guide

Keep exploring

Guides from other topics

All topics →